Journal of Advanced Materials and Technologies

Journal of Advanced Materials and Technologies

An Investigation on Microwave Sintering and Its Effects on Crystal Structure, Microstructure and Microwave Dielectric Properties of Li2TiO3 Ceramic

Document Type : Original Reaearch Article

Authors
Somaye Ghaffari 1
Touradj Ebadzadeh 1
Masoud Alizadeh 2
Keivan Asadian 3
1 Department of Ceramics, Materials and Energy Research Center, Karaj, Alborz, Iran.
2 Department of Ceramics, Materials and Energy Research Center, Karaj, Iran.
3 Department of Semiconductors, Materials and Energy Research Center, Karaj, Iran.
10.30501/jamt.2019.94173
Abstract
In this research, Li2TiO3 ceramic was sintered via heating procedures of conventional and microwave sintering. The maximum density of 3.08 g/cm3 at 1200˚C with 3 h holding time and 3.12 g/cm3 at 1300˚C without any holding time was achieved through conventional and microwave sintering, respectively. The thermal behavior was investigated using DTA-TG, phase analysis was performed by XRD technique, and microstructures were observed by FE-SEM. Also microwave measurements were performed using Network Analyser. XRD investigations showed a higher intensity of (002) peak located at 2θ=18.46˚ in microwave sintered part attributed to higher degree of cation ordering and superlattice formation. Microstructural investigations by SEM revealed the finer microstructures of microwave rather than conventionally sintered parts. The maximum microwave characteristics were measured εr= 20.29 and Q×f = 26191 GHz for parts sintered in a conventional furnace at 1200˚C and εr= 20.86 and Q×f = 25610 GHz for parts sintered in microwave at 1300˚C.
Keywords
Microwave sintering
Li2TiO3
microwave dielectric properties
microstructure
  1. Yuan, L.L. and J.J. Bian, Microwave Dielectric Properties of the Lithium Containing Compounds with Rock Salt Structure. Ferroelectrics, 2009. 387(1),: p. 123-129.
  2. Bian, J.J. and Y.F. Dong, New high Q microwave dielectric ceramics with rock salt structures: (1−x)Li2TiO3+xMgO system (0≤x≤0.5). Journal of the European Ceramic Society, 2010. 30(2), : p. 325-330.
  3. Hao, Y.-z., et al., Enhanced sintering characteristics and microwave dielectric properties of Li2TiO3 due to nano-size and nonstoichiometry effect. Journal of Materials Chemistry, 2012. 22(45),: p. 23885.
  4. Hao, Y.-Z., et al., Microwave dielectric properties of Li 2 TiO 3 ceramics doped with LiF for LTCC applications. Journal of Alloys and Compounds, 2013. 552,: p. 173-179.
  5. Liang, J., et al., A new route to improve microwave dielectric properties of low-temperature sintered Li2TiO3-based ceramics. Journal of Materials Science: Materials in Electronics, 2013. 24(10),: p. 3625-3628.
  6.        Bian, J.J. and Y.F. Dong, Sintering behavior, microstructure and microwave dielectric properties of Li2+xTiO3 (0≤x≤0.2). Materials Science and Engineering: B, 2011. 176(2), : p. 147-151.
  7.        Wang, J., et al., Low-temperature sintered Zn (Nb1−x Vx/2)2 O6−2.5x microwave dielectric ceramics with high Q value for LTCC application. Journal of alloys and compounds, 2005. 392(1),: p. 263-267.
  8.        Zhang, J., Y. Zhou, and Z. Yue, Low-temperature sintering and microwave dielectric properties of LiF-doped CaMg1−x Znx Si2 O6 ceramics. Ceramics International, 2013. 39, (2): p. 2051-2058.
  9. Pei, J., et al., Microwave dielectric ceramics of hexagonal (Ba1−x Ax) La4 Ti4 O15 (A= Sr, Ca) for base station applications. Journal of Alloys and Compounds, 2008. 459(1),: p. 390-394.
  10. Bai, X.-J., et al., Low-temperature sintering and microwave dielectric properties of LiF-doped Ba(Mg1/2W1/2)O3–TiO2 ceramics. Journal of Alloys and Compounds, 2016. 667, : p. 146-150.
  11. Sayyadi-Shahraki, A., et al., Microwave dielectric properties and chemical compatibility with silver electrode of Li2 TiO3 ceramic with Li2 O–ZnO–B2 O3 glass additive. Physica B: Condensed Matter, 2015. 457,: p. 57-61.
  12. Lang, J. and W.-Z. Lu, Microwave Dielectric Properties of Li2TiO3Ceramics Doped with ZnO-B2O3Frit. Journal of the American Ceramic Society, 2009. 92(4),: p. 952-954.
  13.        Liang, J., et al., Microwave dielectric properties of Li2 TiO3 ceramics sintered at low temperatures. Materials Science and Engineering: B, 2011. 176(2),: p. 99-102.
  14.        Sirugudu, R.K., R.K.M. Vemuri, and B. Murty, Microwave Sintering Studies on Low Loss (Zn, Mg) TiO3 Dielectric Resonator Materials. Journal of Microwave Power and Electromagnetic Energy, 2013. 47(4),: p. 262-269.
  15.        Saxena, V. and U. Chandra, Microwave synthesis: a physical concept. 2011: INTECH Open Access Publisher.
  16.        Oghbaei, M. and O. Mirzaee, Microwave versus conventional sintering: a review of fundamentals, advantages and applications. Journal of Alloys and Compounds, 2010. 494(1),: p. 175-189.
  17.        Feizpour, M., et al., Microwave-assisted synthesis and sintering of potassium sodium niobate lead-free piezoelectric ceramics. Ceramics International, 2014. 40(1),: p. 871-877.

 

Journal of Advanced Materials and Technologies
Volume 8, Issue 2
Summer 2019
Pages 53-59

  • Receive Date 26 December 2017
  • Revise Date 31 December 2018
  • Accept Date 23 May 2019