Effect of Synthesis Temperature on the Morphology and Particles Size of Sno/Zno Nanocomposites Synthesized Via Chemical Bath Deposition, CBD (RESEARCH NOTE)

doi:10.30501/jamt.2632.70168

Effect of Synthesis Temperature on the Morphology and Particles Size of Sno/Zno Nanocomposites Synthesized Via Chemical Bath Deposition, CBD (RESEARCH NOTE)

10.30501/jamt.2632.70168

Abstract

In this paper, SNO/ZNO nano-composites have been synthesized via chemical bath deposition, CBD and the effect of synthesize temperature on the particles size and their morphology has been studied. The obtained results show that with increasing the synthesize temperature, the particles size of nano-composite decreases and their morphology changes from plate with width and length median of 58 to 260nm for samples synthesized at 25˚C to sphere with doiameter median of 58 and 50nm for samples synthesized at 50 and 75˚C, respectively. Also, at low temperature the content of SNO nano-particles is lower than that of ZNO. In this research, the type of obtained phases, phase's percent, particles size, morphology and specific surface area were determined by XRD, XRF, Tem, SEM and BET, respectively.

Keywords

Nano-Compposite

Chemical Deposition

Soft Chemistry

SnO/ZnO