@article { author = {Ghaffari, Somaye and Ebadzadeh, Touradj and Alizadeh, Masoud and Asadian, Keivan}, title = {An Investigation on Microwave Sintering and Its Effects on Crystal Structure, Microstructure and Microwave Dielectric Properties of Li2TiO3 Ceramic}, journal = {Journal of Advanced Materials and Technologies}, volume = {8}, number = {2}, pages = {53-59}, year = {2019}, publisher = {Materials and Research Center (MERC)}, issn = {2783-0810}, eissn = {2783-0829}, doi = {10.30501/jamt.2019.94173}, abstract = {In this research, Li2TiO3 ceramic was sintered via heating procedures of conventional and microwave sintering. The maximum density of 3.08 g/cm3 at 1200˚C with 3 h holding time and 3.12 g/cm3 at 1300˚C without any holding time was achieved through conventional and microwave sintering, respectively. The thermal behavior was investigated using DTA-TG, phase analysis was performed by XRD technique, and microstructures were observed by FE-SEM. Also microwave measurements were performed using Network Analyser. XRD investigations showed a higher intensity of (002) peak located at 2θ=18.46˚ in microwave sintered part attributed to higher degree of cation ordering and superlattice formation. Microstructural investigations by SEM revealed the finer microstructures of microwave rather than conventionally sintered parts. The maximum microwave characteristics were measured εr= 20.29 and Q×f = 26191 GHz for parts sintered in a conventional furnace at 1200˚C and εr= 20.86 and Q×f = 25610 GHz for parts sintered in microwave at 1300˚C.}, keywords = {Microwave sintering,Li2TiO3,microwave dielectric properties,Microstructure}, title_fa = {بررسی تف جوشی مایکروویو و اثرات آن بر ساختار بلوری، ریزساختار و خواص مایکروویو دی الکتریک سرامیک Li2TiO3}, abstract_fa = {در این پژوهش تف ­جوشی سرامیک Li2TiO3 به دو روش معمولی و مایکروویو انجام شد. بیشینه چگالی g/cm3 08/3 (58/90 درصد چگالی تئوری) به روش تف­جوشی معمولی در دمای ˚C1200 و با زمان نگه­داری سه ساعت به­ دست آمد در حالی­ که بیشینه چگالی g/cm3 12/3 (76/91 درصد چگالی تئوری) به روش تف­جوشی مایکروویو در دمای ˚C1300 و بدون زمان نگه­داری به­ دست آمد. بررسی رفتار حرارتی به روش DTA-TG، بررسی فازی نمونه­ ها به روش XRD و بررسی ریزساختاری نمونه­ ها به روش FE-SEM انجام گرفت. هم­چنین خواص مایکروویو دی­الکتریک نمونه ­های تف­ جوشی شده اندازه ­گیری شدند. نتایج XRD نشان می­ دهد که پیک (002) که در 2θ=18.46˚ ظاهر می­شود و مربوط به منظم شدن لایه ­های کاتیونی در ساختار و تشکیل ابر شبکه است، در تف­ جوشی مایکروویو از شدت بیشتری برخوردار است. مشاهدات ریزساختاری با SEM نشان می­دهد که قطعات تف­ جوشی شده در کوره مایکروویو نسبت به نمونه مشابه در کوره معمولی ریزدانه ­تر هستند. بیشینه خواص مایکروویو دی­الکتریک پس از تف­ جوشی در کوره معمولی در دمای ˚C1200 حاصل شده و برابر با εr = 20.29 و Q×f = 26191 GHz به ­دست آمد و این در حالی­ است ­که بیشینه خواص مایکروویو دی­الکتریک پس از تف­ جوشی در کوره مایکروویو در دمای ˚C1300 و برابر با εr = 20.86 و Q×f = 25610 GHz به ­دست آمد.}, keywords_fa = {تف‌جوشی مایکروویو,Li2TiO3,خواص مایکروویو دی‌الکتریک,ریزساختار}, url = {https://www.jamt.ir/article_94173.html}, eprint = {https://www.jamt.ir/article_94173_815fa6eedf7daf16d1393fc2043d4182.pdf} }