Synthesis of Al-4.5wt%Cu/TiC Nanocomposite and Nanostructured Al-4.5wt%Cu Alloy via Mechanical Milling Process

Mostaed, Ehsan; Shokuhfar, A.; Saghafian, Hassan; Mostaed, Ali; Rezaie, Hamid Reza

doi:10.30501/jamt.2634.70126

Synthesis of Al-4.5wt%Cu/TiC Nanocomposite and Nanostructured Al-4.5wt%Cu Alloy via Mechanical Milling Process

Authors

Ehsan Mostaed ¹

A. Shokuhfar ²

Hassan Saghafian ³

Ali Mostaed ²

Hamid Reza Rezaie ⁴

¹ school of Metallurgy and Materials Engineering, Iran University of Science and Technology, 16846-13114 Tehran

² Advanced Materials& Nanotechnology Research Center, Faculty of Mechanical Engineering, K. N. Toosi, University of Technology, 16765-3381, Tehran, Iran

³ School of Metallurgy and Materials Engineering, Iran University of Science and Technology, 16846-13114 Tehran

⁴ School of Metallurgy & Materials Engineering, Iran University of Science and Technology, 16846-13114 Tehran

10.30501/jamt.2634.70126

Abstract

Mechanical alloying process has been utilized to synthesis immiscible systems, nanostructured materials, and nanocomposites for decades. In this paper, synthesis and characterization of Al-4.5wt%Cu alloy and its composite, reinforced with TiC, through mechanical milling process are studied. X-ray diffraction technique, scanning electron microscopy and transmission electron microscopy were utilized to characterize the mechanically milled powders. XRD and SEM results indicate the fact that supersaturated solution of Cu in Al occurred during mechanical milling process as a result of mutual diffusion of Al and Cu. In addition, TEM results illustrate the fact that not only mechanically milled powders are nanostructured but also TiC particles had been nanosized after milling process.

Keywords

mechanical alloying

Al - 4.5 wt% Cu

Nanocomposite